AirLive POE-200CAMv2 User Manual
Page 16
AirLive POE‐200CAMv2 User’s Manual
15
appear. Click OK to proceed
;
the network indicator on the device will start to blink. After completing adjustments
to the default settings, the device will reboot automatically. Do not turn off the device until the device reboots.
Backup setting data:Save the setting data of the device to a file. Click Save, and follow the instructions on the
browser to save the setting data file to your specified location.
Restore setting:Load the saved setting data of the device. Click Browse and select the file in which the setting
data is stored. Click OK, and the device is adjusted according to the loaded data and restarted.
Firmware update:Upgrade the device software. Click Browse and select the file for upgrading. A confirmation
dialogue will appear. Click OK to start upgrading. The device will reboot upon completion.
Note:
• Use only upgraded files that are special for this device. Problems may occur otherwise.
• Do not turn off the device power or disconnect the network until the upgrading is completed.
Upload language pack:Upgrade the device language pack. Click Browse and select the file for upgrading. A
confirmation dialogue will appear. Click OK to start upgrading. The upgrade is applied immediately. The default
language is “English.”
6.1.2 Camera
6.1.3 General
RTSP: Switch the RTSP streaming On/Off.
Note:
• RTSP: Real Time Streaming Protocol. RTSP is supported by most of the media clients. (RealPlayer,
Media Player, QuickTime, etc…)
Image Rotate:Enables user to mirror or flip the display screen.
Night Mode:Turn Night Mode ON/OFF.
Lighting:Choose the lighting environment among 50Hz, 60Hz and Outdoor.
White Balance:Choose the White Balance to Auto, Fluorescent, Incandescent and Black&White.