AirLive WLA-5200AP-G - Manual (Page 31)

26 WLA-5200AP v2 User’s Manual
whether there are buffered frames at the access point).
Data Rate By default, the unit adaptively selects the highest
possible rate for transmission. Select the basic rates to
be used among the following options: Auto, 1, 2, 5.5,
11or 54 Mbps. For most networks the default setting is
Auto which is the best choice. When Auto is enabled
the transmission rate will select the optimal rate. If
obstacles or interference are present, the system will
automatically fall back to a lower rate.
Preamble Type A preamble is a signal used in wireless environment to
synchronize the transmitting timing including
Synchronization and Start frame delimiter. In a “noisy”
network environment, the Preamble Type should be
set to Long Preamble. The Short Preamble is
intended for applications where minimum overhead
and maximum performance is desired. If in a “noisy”
network environment, the performance will be
decreased.
Hide SSID Select enabled to allow all the wireless stations to hide
the SSID of this router.
Tx Burst Select the check box to enable the Tx Burst function.
802.11g Protection The 802.11g standard includes a protection mechanism to
ensure mixed 802.11b and 802.11g operations. If there is no
such kind of mechanism exists, the two kinds of standards
may mutually interfere and decrease network’s performance.
Tx Power Level Totally have 6 Tx Power Level, default is Level one
you can select Level2~Level6 to reduce the Tx Power
AckTimeOut Maximum time, in microseconds, that the failover
daemon will wait for an ACK or NOACK message to be
received from the peer failover daemon. For each
message the failover daemon sends, the peer failover
daemon sends an ACK or NOACK message to
indicate that the peer is still functioning.
Default: 50 microseconds
Enable Watch Dog
Watch Interval
Watch Host Check the box to enable this watch dog function
and set the Watch dog time Interval (1~60 mins)
and type the ip address of the host ip
Apply Change
Press to save the new settings on the screen.
Reset Press to discard the data you have entered since last
time you press Apply Change.