AirLive WLA-5200AP-G - Manual (Page 43)

38 WLA-5200AP v2 User’s Manual
Alias Name You can set the alias name for this device (not exceeding 32
characters).
Disable
Wireless
LAN
Interface Check the box to disable the Wireless LAN Interface, by so doing,
you won’t be able to make wireless connection with this Access
Point in the network you are located. In other words, this device will
not be visible by any wireless station.
Band You can choose one mode of the following you need.
• 11b/g mixed: Select to allow both wireless-b and wireless-g devices on the
network.
• 11B only: Select to allow only wireless-B devices on the network.
• 11G only: Select to allow only wireless-G devices on the network.
• 11A (indoor): Select to allow only wireless-A devices on the indoor
network.
• 11A (outdoor): Select to allow only wireless-G devices on the network.
• 11A (indoor): Select to allow only wireless-A devices on the outdoor
network
.
AP SSID The SSID differentiates one WLAN from another; therefore, all
access points and all devices attempting to connect to a specific
WLAN must use the same SSID. It is case-sensitive and must not
exceed 32 characters. A device will not be permitted to join the BSS
unless it can provide the unique SSID. An SSID is also referred to
as a network name because essentially it is a name that identifies a
wireless network
WISP SSID The SSID differentiates one WLAN from another; therefore, all
access points and all devices attempting to connect to a specific
WLAN must use the same SSID. It is case-sensitive and must not
exceed 32 characters. A device will not be permitted to join the BSS
unless it can provide the unique SSID. An SSID is also referred to
as a network name because essentially it is a name that identifies a
wireless network
Channel
Number The number of channels supported depends on the region of this
Access Point. All stations communicating with the Access Point
must use the same channel.
SSID of
extended
Interface
When in Universal Repeater mode, you have to enter the ESSID of
other’s AP/Router that device want to connect.
The device SSID and the SSID of extended interface can be the
same or different. When you are using the universal repeater mode,
please make sure the remote AP/Router WDS function is turned off.