APG FLR Series user manual - Manual (Page 11)

Rev. A5, 10/09 FLR Series
11
Automation Products Group, Inc.
APG...Providing tailored solutions for measurement applications
Tel: 1/888/525-7300 • Fax: 1/435/753-7490 • www.apgsensors.com • [email protected]
5. Carefully remove the terminal mounting plate along with the wiring and
internal reed switch assembly from the stem of the FLR. Keep the assembly
straight and take care not to bend or put stress on the reed switches.
4. Once the stops and float are set in the desired location, the reed switch
assembly inside the stem needs to be adjusted to match the new actuation
point. To access the reed assembly, you will need to remove the two screws
that secure the terminal mounting plate to the housing.