Atop Technology SW550X User manual - Manual (Page 30)

Atop Industrial Wireless Serial Device Server Series
SW550X
User Manual V 1.1
24
Fig. 3. 7
 Default Gateway Selection specifies whether you are intending to use wireless or LAN
interface as the default gateway. The selected interface is usually the one that is
connected to a gateway or Internet. Settings from one of them will not be applicable to
the other, i.e., if the WLAN is selected over the LAN then IP, Subnet mask, etc., on the
LAN side will be OFF. You can still however be able to change the values of the one not
in use and save those parameters.
Under the AP Client mode, you will only see one bridged interface and the default gateway
selection is unnecessary (Fig. 3. 8).