Atop Technology SW550X User manual - Manual (Page 67)

Atop Industrial Wireless Serial Device Server Series
SW550X
User Manual V 1.1
61
 Click on the “COM1” link on the left hand side.
Fig. 4. 7
 Select TCP Client in the Link modes.
 Only two communication modes are available here: RAW and Virtual COM which
definitions are the same as above in Sec. 4.1.1 .
 Enter the preferred Destination IP and Port. This should match the IP settings of the
TCP Server program.
 Enable and enter Destination IP 2 and Port 2 if necessary. Two different servers can
be set here (for redundancy), the second server has to be enabled by ticking the box.