Atop Technology SW550X User manual User Manual
Page 8
Atop Industrial Wireless Serial Device Server Series
SW550X
User Manual V 1.1
2
two conditions:
1
This device may not cause harmful interference, and
2
This device must accept any interference received, including interference that may
cause undesired operation.
This device and its antenna(s) must not be co-located or operating in conjunction with any
other antenna or transmitter.
FCC Caution: Any changes or modifications not expressly approved by the party responsible
for compliance could void the user's authority to operate this equipment.
For product available in the USA/Canada market, only channel 1~11 can be operated.
Selection of other channels is not possible.
※
This device is restricted to indoor use when operated in the 5.15 to 5.25 GHz frequency range
use. FCC requires this product to be used indoors for the frequency range 5.15 to 5.25 GHz to
reduce the potential for harmful interference to co-channel Mobile Satellite systems.
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum distance 20cm
between the radiator & your body.
European Community, Switzerland, Norway, Iceland, and Liechtenstein
Model: SW550X Series
Declaration of Conformity with regard to the R&TTE Directive 1999/5/EC
This equipment is in compliance with the essential requirements and other relevant provisions
of 1999/5/EC.
The following standards were applied:
EMC
—EN 301.489-1 v1.4.1; EN 301.489-17 v1.2.1
Health & Safety
—EN60950-1: 2001; EN 50385: 2002
Radio
—EN 300 328 v 1.7.1; EN 301.893 v 1.5.1
The conformity assessment procedure referred to in Article 10.4 and Annex III of Directive
1999/5/EC has been followed.
This device also conforms to the EMC requirements of the Medical Devices Directive
93/42/EEC.
Note This equipment is intended to be used in all EU and EFTA countries. Outdoor use may be
restricted to certain frequencies and/or may require a license for operation. For more details,
contact Cisco Corporate Compliance.