BLITZ SBC Type-S & R - Manual (Page 10)

■Wastegate Type（Poppet Valve）
１．Take the boost pressure between the turbo charger's compressor cover and the throttle body
are connected to the valve IN to make sure of using the clamps supplied from the kit.
２．Connect the valve OUT to the room A of the waste gate to make sure of using the clamps supplied
from the kit.
３．The boost pressure must be connected from the compressor cover and room B of the waste gate
to make sure of using the clamp supplied from the kit.
Room A
Turbo Charge
Wastegate
Throttle Body
Intake Manifold
Room B
Valve IN
Valve OUT
Compressor Cover
Intake Pipe
This is the basic installation of this product.
TYPE S
－ Installation Method ④ －
IN OUT
TYPE R
※Only for Type R
Set as WG on the various
setting (Detailed on page 15)
９