BLITZ SBC Type-S & R - Manual (Page 13)

－ Operation Method ③－
■Set for Warning and Boost limiter
１．Use ▼▲ to choose warning when the display brinks,
then press to decide.
（SET shows and WR brinks）
２．Use ▼▲ to choose the boost pressure, then press to decide.
Off～3.00hkPa（43.5PSI）
WR ON … WR shows
WR OFF … WR not shows
３．Use ▼▲ to choose boost limiter, then press （-99～100）
0 ……………… Limiter Off
-99～-1 … When the set pressure of boost hits
control of decreasing until the set pressure of DUTY.
1～100 …… When the set pressure of boost hits
control of increasing until the set pressure of DUTY.
※LO/HI can be set on different setting.
＜Example＞Set Pressure of DUTY is 50.
・If the limiter is set -20,
it will be controled 30 when the warning hits.
・If the limiter is set 20,
it will be controled 70 when the warning hits.
１２