BLITZ SBC Type-S & R - Manual (Page 9)

■Actuator Model（Swing Valve）
IN port
OUT port
Turbo Charger
＜For Single Turbo＞
Take out factory fitting
OUT port
IN port
3 way joint
※Needs to purchase as an optional （PN：14026)
■Installtion of twin solenoid valve.
１．Do not install at highly heated or humid location inside the engine compartment.
（install the piping within 1 meter from the Turbo Charger）
[Advive]
Long piping is the cause of slow response which will cause over shooting and hunching of boost pressure.
－ Installation Method ③ －
＜For Twin Turbo＞
８