BLITZ SBC Type-S & R - Manual (Page 12)

－ Operation Method ②－
■Peak Mode
＜After Peak＞
１．Use ▼▲ to adjust THE peak when the display flashes,
then press to set.”PK” will flash.
２．Boost will be displayed in real time.
If maximum boost achieved is equal to or greater than the PEAK setting,
This level will flash for 3 seconds. If maximum boost achieved is lower
than the set level, the display will return to the PEAK setting.
３．Press the button to display boost.
Press ▲ to display PEAK boost
＜Peak Hold＞
１．To display PEAK boost, press the button, (or during AFTER PEAK,
press ▲▼ together)
PK will flash slowly
Display will return to normal once PEAK boost is achieved again
２． Press to display boost
• PEAK boost memory can be reset by holding ▲▼ together for 2 seconds
１１