BLITZ SBC Type-S & R - Manual (Page 8)

■Piping to Valve Unit
●Solenoid Valve（TYPE S）
Install the nipple follows by top plate.
Actuator and Waste gate has a different installation method.
Remove all the caps.
Fuel
Pressur
Regulator
Fuel Tube
Cut the hose
Intake Manifold
T pipe Joint
Nylon hose into the vehicle
■Piping to Intake Manifold
Washer
Rubber Washer
Washer
Rubber Washer
※Due to the characteristics of solenoid valve, vibration and noise will come out, but this is not defective.
Install firmly and use φ6 crecent clamp to tie the hose.
●Dual Solenoid Valve（TYPE R）
Install carefully IN/OUT port by looking body stamp.
Using dual solenoid valve controlled by waste gate only, change the setting to GT.
（Detailed information is written on page 15）
ＩＮ ＯＵＴ
Actuator Type
Wastgate Type
Using by 1/8 taper thread cannot inseat very far.
Using by 1/8 taper thread cannot inseat very far.
－ Installation Method ② －
※Due to the characteristics of solenoid valve, vibration and noise will come out, but this is not defective.
Install firmly and use φ6 crescent clamp to tie the hose.
７
Please secured by wire tie