BLITZ SBC Type-S & R - Manual (Page 11)

－ Operation Method ① －
■Set for Boost Pressure
１．While display is flashing, use ▼▲ to adjust
desired boost level, then press button
to set.
２．Hold the button for 2 seconds while
in“boost”mode.
３．When“SET”is flashing, use ▼▲ to adjust
“DUTY”then press button to set.
４ Use ▼▲ to adjust“GAIN”then press to set.
５．Use ▼▲ to adjust“P-GAIN”then press
button to set.
If“P-GAIN”is set to“0”, then“P-GAIN”will be
disabled.
６．When the“SET”turns off, the boost setting
will be displayed.
１０
Boost
RPM 0
Setting on P-GAIN
DUTY - Duty setting will be maximum allowable boost pressure. This value
will be set from 0-100 read as a percentage, or ratio. A“0”value
will be minimum boost allowed at W/G setting, where as a value of
“100”will be at maximum, or unlimited boost. * It is recommended
to begin at a low value (10-20) and slowly increase the value as
required AFTER testing. Too high of a value will result
in overboost and could result in severe engine damage.
GAIN - Gain is used for controlling boost response.
This value will be set from 0-100 read as a percentage,
or ratio. A “0” value will be slow boost response,
where as a value of “100” will be maximum boost response.
* It is recommended to begin at a low value (10-20) and
slowly increase the value as required AFTER testing.
Too high of a value could cause boost spikes and could
result in severe engine damage.
P-GAIN - Peak Gain is used to stabilize boost level AFTER
reaching PEAK or MAXIMUM set boost level.
This value will be set from 0-100 and should be
adjusted to maintain a stable maximum boost level.
Too high of a correction value will result in over
correction, and boost levels will not be maintain
at the desired boost setting.
Boost
RPM 0
Setting on GAIN