Caron 7000-75 User Manual

Page 11

Advertising
background image

7000-50 & 7000-75 Series Operations Manual Rev A 1/6/2014

Page 11 of 71

Choose a location where these facilities are, or can be made available. If a water

source or a drain is not available, contact CARON customer service and ask about our

CRYS102 product line or click this web link for information on the product:

http://www.caronproducts.com/65

Preliminary Cleaning

Your new environmental chamber was thoroughly cleaned prior to leaving the factory.

It is recommended however, to disinfect all interior surfaces with a general purpose

laboratory cleaning agent prior to using the product. After cleaning, dry all interior

components with a sterile cloth as necessary.

Installing the Port Stoppers

The unit has an access port built into each side of the cabinet. The ports are designed

to allow customer access for equipment validation and for installation of other

equipment inside the chamber. These ports should be sealed with the provided rubber

stoppers to allow the chamber to function properly. Install the stoppers provided in the

port on each side of the unit.

Installing the Shelves

Each new 7000-50 Series environmental chamber includes eight perforated stainless

steel shelves. Each new 7000-75 Series environmental chamber includes twelve

perforated stainless steel shelves. Each shelf requires two shelf channels for

installation. The left and right shelf tracks are the same. Prior to installation, take time

to consider what the size of the product being placed in the chamber will be and set the

shelf spacing accordingly. Additional shelving can be purchased through CARON

customer service if necessary. The chamber should be empty when being moved.

To install the shelf channels insert the rear tab on the shelf channel into the rear wall

on the side wall of the chamber. Then insert the front tab into the front pilaster. Push

the entire shelf channel towards the rear of the unit and snap it down into place.

Each shelf is capable of supporting a uniformly

distributed load of 50 pounds. The maximum

chamber capacity (stationary) is: 500 pounds (2-door)

and 750 pounds (3-door).

Advertising
This manual is related to the following products: