EZWatch Pro 3.1 User Manual
Page 150
150
4. When the program is up
and running and your
cameras
are
being
displayed on the screen,
click on the setup button
that shows a hammer and
file at the bottom/middle
of the screen. This is the
System
Configuration
Window that allows you to
setup the controls for the
PTZ cameras that you
have just installed.
Towards the bottom left hand corner where it says NetCom Module,
make the following selections to set up the system for PTZ operation.
a. Model: select 3213USB
b. Com Port: select the com port number from the previous
step.
c. Baud Rate: this is the speed or rate at which the PC
communicates with the cameras. This should always be at
9600 to ensure proper operation.
Now click on OK to save your setting and close the window.
5. Now we need to setup the communication for
each of the PTZ cameras. Click on the following
button to display the camera configuration
screen that is shown to the right.
A t the top the cam era is show n as “C am era 01”,
use the down arrow to choose the camera number you want to set