EZWatch Pro 3.1 - Manual (Page 60)

60
Step4: Press the ―O K ‖ button to complete the areas setting.
 To delete a setting detection area , please follow the setting steps
below:
Step1: Select a setting detection area by mouse right button.
Step2: Press the “Delete area” to delete.
Step3: To delete another setting detection area, please repeat step1 to
step2.
Step4: Press the ―O K ‖ button to complete the areas setting.
If enable the “M otion detection recording” in the “S et up schedule” section
of the “R ecording” tap, but not specific a detection area in the “S et up area”
section of the “M otion setting” tab, the full area w ill be the default setting.
 Hardware detection (Optional)
You can also select hardw are detection. A fter enabling “Hardware
detection”, select the specific sensor to use from available port. You need to
connect the sensor device to the port of “Sensor in” of “N etC om m odule‖.
When the sensor is triggered, it will start to record and trigger the port of
relay output.
 Tolerance – This function is to prevent false alarms by defining
acceptable movement. If the tolerance is set 2, video screen must change
continuously 3 times before the DVR recording.
 Post recording – This function sets the time to continue recording after
motion is no longer detected; the video will be saved as a file. If the time
between one motion detection period and a new motion detection period
is less than the value in this field, the two recordings will be combined. It
will reduce the motion detection video file and notification.
 Pre-alarm