EZWatch Pro 3.1 - Manual (Page 156)

156
playback.
The following steps will help you set up the system to audio/video record a
camera.
1. Plug your microphone into the back of your computer. Usually the
microphone input is the pink input.
2. Plug your speakers into the line out on the back of your computer.
This is usually the green input.
3. If you haven’t already, close the EZWatch Pro program so you are
looking at the desktop. Then double click on the Set up Video
Parameters Icon.
4. At the bottom of this window click on the Setup Audio Recording
button.
5. Choose your audio device. This is the sound card you have in your
machine. Then choose your audio source which will be microphone
and then finally choose the camera to which you want the sound to
be recorded to.
6. Click OK (twice) to save the settings and to go back to the desktop.
Now start up EZWatch Pro.
7. In the EZWatch Pro program click on the camera configuration
button.
8. Choose your camera that you selected in the previous setup for
audio recording. Click on the recording tab for that camera. Select
enable audio recording. Click OK so you are back looking at your
camera display.
9. After completing these steps stop and restart the recording on the
selected camera. This will start a new video clip recording with the
audio feed.
You are now recording audio with video on your EZWatch Pro system. To
check this out simply allow the recording to run for a little while then stop it
and restart it and go into playback video clips and search for the clip you
just recorded. Make sure your speakers are turned on and volume is turned
up to allow you to hear the sound.