EZWatch TurboView DVR - Manual (Page 17)

17
2.1.2 Internal SATA Storage (E, F and G Type)
 These series DVRs have 5 Internal SATA Ports: The picture below shows internal ports 1-4 SATA Port and 5 SATA Port.
 1-3 SATA Port: It is designed to mount HDD.
 4 SATA Port: Please mount DVD-RW.
 5 SATA Port: It is specifically designed to mount HDD ONLY.
 Only one DVD-RW can be installed among the SATA Ports.
CAUTION
Do not mount DVD-RW at SATA 5 Port.
2.1.3 e-SATA External Storage (E, F and G Type)
 This series DVR has 2 external SATA Ports; the picture above shows external SATA 6-7 Port.
 6-7 SATA Port: It is designed to mount 4HDDs per each external SATA Ports.
2.1.4 HDD Installation
 Securely fix a hard disk by using bracket and screws provided herewith.
 Please do not use any different hard disk cables (data cable and power supply cable) other than ones we provide.
 Otherwise, it may cause damage to the hard disk.
CAUTION
Install hard disk after DVR power is off. Otherwise, it may cause permanent damage to the hard disk. To turn off DVR, please click ( )
SETUP>SYSTEM>Shutdown. Also, wait for 5 seconds before plugging in power supply again.
CAUTION
 For installation/addition/replacement/Removal of HDD (DVD-RW), make sure that DVR is turned off. Otherwise, it may cause permanent
damage to the HDD (DVD-RW).
 Installation/Addition/Moving/Replacement: User should start ‘HDD initialization’ including formatting. Otherwise, DVR won’t recognize
the hard disk and may begin to function abnormally. Please follow the below procedure for ‘HDD initialization’.
① (Date/Time setup) Set up the current date and time (SETUP>SYSTEM>Admin>Date/Time)
② (Initialization of system setup) All values in setup are restored to factory default settings
- (SETUP>SYSTEM>Information>Status>Setup>Default)
③ (HDD format) HDD format is done by SETUP>SYSTEM>Admin>Storage>Format. If there are more than two HDDs, each must be
formatted, separately. When the format is completed, DVR will auto-reboot.
 Removal: Follow the Remove procedure even when a pre-installed hard disk has been removed. In
- SETUP>SYSTEM>Admin>Storage>Format, click ( ) ‘Removed’ item under the discrete Format headings of a corresponding HDD to
discard ‘HDD’ item. When the Remove procedure is completed, DVR will auto-reboot.