EZWatch TurboView DVR - Manual (Page 19)

19
 If user wishes to hear audio via HDMI cable, check the box HD Audio Output
 Click the box below to select resolution.
- User can select the resolution among ‘1920x1080 RB’, ‘1920x1080’, ‘1680x1050 RB’, ‘1680x1050’, ‘1280x1024’, and
‘1024x768’
- The default setting of DVR is ‘1280 x 1024’.
(NOTE)
 Only D, E and F Types support HDMI connection.
- Only D and E Type supports HDMI connection and Multi Spot.
- F and G Type do not have Multi Spot. But support HDMI.
2.2.4 Audio Connections
 Connect an audio device to ‘AUDIO IN’ and a speaker system to ‘AUDIO OUT’. Please use a speaker system with volume
adjustable.
2.2.5 TCP/IP(Ethernet) Connections
 Connect to ‘ETHERNET’ connector with the LAN cable.
 When connect to Internet, use an ordinary LAN cable (Non-cross cable). However, when connect directly to a PC, please
use only ‘Crossover cable’.
2.2.6 Alarm Connections
 Connect Alarm Input (Sensor) to ‘AI 1~AI 4 (AI 16)’ connectors and connect Sensor Common to ‘G’ connector.
 Connect Alarm Output (buzzer, siren, etc.) to ‘AO 1~AO 4 (AO 16)’ connectors and connect Common to ‘G’ connector.
 Connect Pan/Tilt receiver (or Pan/Tilt camera) to ‘RS-485/422’ connector. Please observe proper (+) and (-) polarity.
2.2.7 RS-485/422 Connections
 PTZ Camera connector.
 Please use TX+, TX-, RX+ and RX- terminals.
2.2.8 USB Connections
 There are four identical USB ports in front and in rear. It is possible to connect a USB memory stick to archive data or a
mouse to control the device.
2.2.9 RS-232 Connections
 This port is not in use for users. Do not connect any devices through this port.
2.2.10 Factory Reset Switch
 Reset the switch to restore all setup values of menus to factory default settings. It is also possible to use to initialize System
Log file.
 The switch is located in a pin hole of the back panel.
 Put the clip pin into the switch hole on the monitor (Live) screen and keep pressing until the switch has clicked.
CAUTION
Press factory reset switch only in live mode. Never press in setup mode.