EZWatch TurboView DVR - Manual (Page 57)

57
 Select cameras for recording while the motion sensor is in operation and alarm outputs and set up E-mail addresses for
notification.
 Link Notification displays E-mail addresses registered in DEVICES>Network>Notification.
 Please follow the setup procedures below.
① Click ( ) Motion Event frame and select Motion Event 1.
② Select cameras for recording when Motion Event 1 is on. Please check  a check box under Link Camera. More than
two cameras can be set.
③ Select alarm outputs to be worked when Motion Event 1 is on. Please check  a check box under Link Alarm Out. More
than two alarm outputs can be set.
④ Select E-mail addresses for notification when Motion Event 1 is on. Please check  a check box under Link Notification.
More than two E-mail addresses can be set.
⑤ Repeat the above procedure for Motion Event 2~ Motion Event 16.
 Click( )By Duration box to set up the recording duration and prevent recording caused by event.
 The duration time can be controlled by previous setting mode: RECORD>Settings>Event
 Choose ‘OK’ to confirm the setting.
4.6.3 Video Loss
 Please click ( ) LINK>Video Loss and the following screen will appear.
 Select cameras for recording while the motion sensor is in operation and alarm outputs and set up E-mail addresses for
notification.
 Link Notification displays E-mail addresses registered in DEVICES>Network>Notification.
 Please follow the setup procedures below.
① Click ( ) Video Loss frame and select Video Loss 1.
② Select cameras for recording when Video Loss 1 is on. Please check  a check box under Link Camera. More than two
cameras can be set.
③ Select alarm outputs to be worked when Video Loss 1 is on. Please check  a check box under Link Alarm Out. More
than two alarm outputs can be set.
④ Select E-mail addresses for notification when Video Loss 1 is on. Please check  a check box under Link Notification.
More than two E-mail addresses can be set.
⑤ Repeat the above procedure for Video Loss 2~ Video Loss 16.
 Click No Beep  to deactivate alert sounds from video loss. Apply to all channels.
 Choose ‘OK’ to confirm the setting.