Garland HO IN 1500 INDUCTION TEMPERATURE CONTROLLED BUILT-IN HOLD-LINE - Manual (Page 14)

Installation RTCSmp Built-In Temperature Controlled Hold-Line
14 Part # 4532288 Rev 3 (6/11/14)
4.5 Control Unit Installation
The induction unit comes with two control units. The cable for each control is 39” (100cm) long. There are LED
Indicator Lights on the control units for the RTCSmp Hold-Line models.
NOTE
 Install the control units VERTICALLY on the cabinet panel. There are two methods to install a control
unit: front-mount or back-mount onto the panel.
 Installers are responsible for choosing the appropriate fasteners for the installation.
 The RJ-45 connectors are located on the bottom of the
unit.
 The digital displays underneath the Ceran glass are on
the opposite side of the RJ45 connectors.
 The controls should be installed on the same side as the
digital displays (Front). For parallel installation (see
4.4.3), the controls are to be installed on the Left/Right
side of the units.
4.5.1 Dimensions: Control Unit RTCSmp HOIN1500
(measurements in mm and [inch])
FRONT:
Digital Displays
under Glass-Top
Plugs for
Control Units
SIDE
(Left/Right)