Garland HO IN 1500 INDUCTION TEMPERATURE CONTROLLED BUILT-IN HOLD-LINE - Manual (Page 21)

Cleaning RTCSmp Built-In Temperature Controlled Hold-Line
Part # 4532288 Rev 3 (6/11/14) 21
7 Cleaning
The cleaning of the Ceran glass is identical to cleaning other similar
glass surfaces. You may use any regular glass cleaning products
available from a hardware store.
CAUTION
Ensure no liquid can get into the induction unit.
Do not use hoses to clean or power wash the
induction unit or its vicinity.
IMPORTANT
 DO NOT USE: corrosive or abrasive cleaning agents, such as grill sprays, oven sprays, stain removers, rust
removers, scouring powder, and rough sponges.
 Let the Ceran glass-top cool down before cleaning.
 Ensure to remove all residues of cleaning agents from the glass-top. Use a clean moist cloth to wipe off
any such residues.
IMPORTANT Air Intake Filter
A dirty, blocked air intake filter can cause electronic damage to the induction unit. The Air Intake Filter is
inserted into the holder at the bottom of the unit. Check and clean the filter at least once a week or as often as
required. The Air Intake Filter is dishwasher-safe. Ensure the filter is DRY before putting it back into the
unit.
Glass Cleaning
1. Use razor blade scrapers or non-scratching sponges to remove all residues on the glass.
When scraping, ensure you angle your
razor blade scraper at about 20
o to 30 o
from the glass.
2. Wipe the glass clean with a damp cloth.
Visual Inspection of Silicone Seal
Check the silicone seal around the glass. Call for service as soon as possible if you notice:
 Cracks on the silicone seal.
 The silicone seal comes away from the glass or moves when you press down on the seal.
When the silicone seal is broken, water penetration can cause the induction unit to fail, which may also lead
to personal harm.
20 o - 30 o