GeoDesy GD-Geo20 - Manual (Page 21)

21
address assigned by the DHCP server is not predictable.
Method
– specify IP reception method: IP addresses can either be retrieved from a DHCP server or
configured manually:
 Static IP – the IP address must be specified manually.
 Dynamic IP – the IP address for this device will be assigned from the DHCP server. If DHCP
Server is not available; the device will try to get an IP. If has no success, it will use a fallback IP
address (default fallback IP is 192.168.2.66). The fallback IP settings can be changed to custom
values.
IP Address
– specify IP address for device
Subnet mask
– specify a subnet mask for device.
Default gateway
– specify a gateway IP address for device.
DNS server
– specify the Domain Naming Server.
Enable IP alias
– specify the alternative IP address and the netmask for APC unit management.
VLAN to SSID Mapping
Virtual Local Area Networks (VLANs) are logical groupings of network resources.
VLAN to SSID mapping
– specify the VLAN ID for traffic tagging on required radio interface [2-4095].
The Station devices that associate using the particular SSID will be grouped into this VLAN.
Management VLAN
Available only on Bridge network mode.
Access to the AP for management purposes can further be limited using VLAN tagging. By defining
Management VLAN, the device will only accept management frames that have the appropriate
Management VLAN ID. All other frames using any management protocol will be rejected.
When you specify a new management VLAN, your HTTP connection to the device will be lost. For
this reason, you should have a connection between your management station and a port in the
new management VLAN or connect to the new management VLAN through a multi-VLAN router.
Enable
– select to enable a VLAN tagging for management traffic.
Management VLAN ID
– specify the VLAN ID [2-4095]. When device interfaces are configured with a
specific VLAN ID value, only management frames that matching configured VLAN ID will be accepted
by device.