GeoDesy GD-Geo20 - Manual (Page 23)

23
MAC address
– specify the clone MAC address if required. The ISPs registers the MAC address of the
router, and allows only that MAC address to connect to their network. In such case if there is need to
change hardware (router), you need to notify your ISP about MAC address change, or simply set
The router’s MAC address to the MAC address of the previously router/computer.
VLAN ID
– specify the VLAN ID for traffic tagging on required radio interface [2-4095]. The Station
devices that associate using the particular SSID will be grouped into this VLAN.
WAN mode
– choose Static IP to specify IP settings manually. This option needs parameters listed
below:
IP address
– specify static IP address.
Subnet mask
– specify a subnet mask.
Default gateway
– specify a gateway.
DNS server
– specify primary and/or secondary DNS server
Enable IP alias
– specify the alternative IP address and the netmask for APC unit management.
WAN mode
– choose Dynamic IP to enable DHCP client on the WAN side. This option does not need
Any parameters.
MAC address
– specify the clone MAC address if required. The ISPs registers the MAC address of the
router, and allows only that MAC address to connect to their network. In such case if there is need to
change hardware (router), you need to notify your ISP about MAC address change, or simply set
The router’s MAC address to the MAC address of the previously router/computer.
VLAN ID
– specify the VLAN ID for traffic tagging on required radio interface [2-4095]. The Station
devices that associate using the particular SSID will be grouped into this VLAN.
DHCP fallback setting
– specify IP address, Subnet mask, Default gateway and optionally DNS
server for DHCP fallback. In case the APC unit will not get the IP address from the DHCP, the
specified fallback IP settings will be used.
Enable IP alias
– specify the alternative IP address and the netmask for APC unit management.