GeoDesy GD-Geo20 - Manual (Page 35)

35
Enable DFS
– select to enable radar detection. With enabled DFS, APC unit monitors the operating
frequency for radar signals. If radar signals are detected on the channel, the unit randomly selects a
different channel.
Mode
– choose the unit’s antenna operating mode:
 SISO – single input single output. The device will use only one antenna for data transfer. The
antenna will be chosen automatically.
 MIMO – multiple input multiple outputs. The device will use two antennas for data transfer (two
Simultaneous streams).
Max data rate
– select the device data transmission rates in Mbps from the drop-down list. The APC
Will attempt to transmit data at the highest data rate set. If there will be an interference encountered,
The APC will step down to the highest rate that allows data transmission.
Transmit queue length, frames
– specify the length in frames of the transmit queue.
7.2.8 Wireless Mode: iPoll Station
The iPoll Station is a wireless client mode which can connect to the iPoll Access Points.
Basic Settings
Use this section to setup basic operating settings of the iPoll Station radio.
iPoll Access Point and iPoll Station will operate in 802.11n IEEE mode only.
SSID
– specify the SSID of the wireless network device manually, or use Scan functionality.
Scan
– click this button to scan for surrounding iPoll Access Points. Found network SSID‟s will be
Available in drop down menu.
Channel width
– The default channel bandwidth for 802.11 N radio is 20/40MHz. The 802.11n allow
channel bonding in such way the total channel width becomes 40MHz.