GeoDesy GD-Geo20 - Manual (Page 28)

28
 Open – no encryption.
 WEP – 64bit and 128bit key.
 Personal – preshared key encryption with WPA/WPA2 using AES or TKIP.
 Enterprise – RADIUS server based authentication with WPA/WPA2 encryption using AES or
TKIP (requires configured RADIUS server).
 UAM – Web browser based user authentication method. UAM authentication is available only if
Access Point is working in router mode. For UAM configuration details refer at the respective
chapter
Universal Access Method (UAM).
By default there is no encryption enabled on the device:
WEP encryption can be either 64bit or 128bit:
WEP passkey
– specify the passkey, for the chosen WEP security:
 For WEP 64bit encryption – 5 HEX pairs (e.g. aa:bb:cc:dd:ee), or 5 ASCII characters (e.g.
abcde);
 For WEP 128bit encryption – 13 HEX pairs (e.g. aa:bb:cc:dd:ee:ff:gg:hh:00:11:22:33:44), or 13
ASCII characters (e.g. abcdefghijklm);
To setup Personal WPA/WPA2 encryption, need to specify the pre-shared key and encryption with
chosen AES, TKIP or Auto method:
Passphrase
– specify WPA or WPA2 passphrase [8-63 characters]. The passphrase will be
converted to key format, selected above.
Encryption
– specify WPA/WPA2 encryption algorithm:
 AES – APC will accept clients with passphrase encrypted with AES method only;
 TKIP – APC will accept clients with passphrase encrypted with TKIP method only;
 Auto – APC will accept clients with passphrase encrypted with both: AES and TKIP methods;
AP has possibility to configure Enterprise WPA/WPA2 encryption with RADIUS authentication.
Properly configured AP will accept wireless stations requests and will send the information to
configured RADIUS server for client authentication.
The properly configured RADIUS server is required for Enterprise WPA/WPA2 encryption.