HYDAC HMG 3010 - Manual (Page 13)

HMG 3010 Page 13
Edition 11/2011 - V04 R01 Part No.: 669855
5 Getting Started Guide
This Getting Started Guide outlines the basic steps for conducting a simple measurement
(measured values shown in display) and plotting a measurement curve (graph of measured
values). The examples involve pressure measurement using 2 pressure transmitters with
sensor detection (HSI sensors). For a detailed description of all the settings, see Detailed
Operating Instructions.
The examples are based on the factory settings of the HMG 3010. Simply follow the
steps described here. If you don’t know the status of your HMG 3010 because there
might be more than one user in your company using the HMG, you can simply restore
the unit to its "as supplied" condition (see Manage Settings — Restore Factory Settings).
Preparation for Performing a Measurement
First charge the batteries or connect the power supply as described in Power Supply.
Two HYDAC HDA 4748-H-0400-000 pressure transmitters with automatic sensor detection
are used in the following example.
Example of a Simple Measurement Us-
ing Two Pressure Transmitters
Connect the two pressure transmitters
hydraulically to your machine and connect
the two pressure transmitters using the sen-
sor connector cables, e.g. to sockets
A and B of the HMG 3010.
After the HMG 3010 is switched on it jumps
to the Current Measured Values menu. The
function bar contains various functions pro-
viding quick access to the three main menus:
- Settings
- Recording
- Extras
and to the display of the
- Min/Max values.
.
Title bar
Function bar