HYDAC HMG 3010 - Manual (Page 14)

HMG 3010 Page 14
Edition 11/2011 - V04 R01 Part No.: 669855
When HSI sensors with automatic sensor
detection are used, the HMG automatically
detects the measurement range and the unit
of measurement of the two connected pres-
sure transmitters and shows them in the dis-
play with the actual measured values. You
can also display the minimum and maximum
values for the sensors.
To hide or show the Min/Max display, press
the right arrow of the 5-way navigation key
until Min/Max is highlighted in blue and then
press the OK key. The Min/Max values of the
sensors are now also displayed. Press the
OK key again to hide the Min/Max display.
When the Min/Max values are shown, Reset
appears in the function bar, enabling you to
reset the Min/Max values as required. Select
Reset using the arrow keys (blue highlight)
and then press the OK key to reset the
Min/Max values.
The measured values can also be displayed
in a 7-segment pane. To do this, go to Set-
tings in the function bar and then press OK.
In the Settings menu, navigate to Change
display settings using the 5-way navigation
key, and then confirm with OK (see screen-
shot of two-pane display on the next page).
Now select the second item, Measured
value rendering. Measured value table is
the default setting here. Press OK. A drop-
down list appears in which you navigate to 2
display panels using the arrow keys, fol-
lowed by confirming with OK. To return to
the measured value display press Esc twice.