HYDAC HMG 3010 - Manual (Page 34)

HMG 3010 Page 34
Edition 11/2011 - V04 R01 Part No.: 669855
Note!
Automatic conversion of measured values
to the selected unit of measurement will not
work unless Automatic detection (HSI)
mode is selected under Settings – Meas-
urement Channel Settings.
Select the unit of measurement to be
changed, followed by OK. Select the new
unit of measurement desired from the drop-
down list by pressing OK.
In the list of measurement channels, the
measurement range for this channel is now
shown in 0 ... 1450 psi instead of in 0 ... 100
bar for example.
In the current measured values display
the measured values show psi readings
(listed after the channel or sensor designa-
tion).