INFICON SRT-422 Crucible Indexer - Manual (Page 31)

Installation Page 29
0003
Section 3
Installation
Section 3.1: Introduction
The Indexer is shipped from the factory with an assigned home position for pocket #1.
In general, it will be difficult to install the Indexer in such a manner that home position of pocket
#1 of the Indexer correspond exactly to the actual center of pocket 1 of the source. The need
to adjust the phase between the Indexer and the E-Beam Source will generally occur after the
initial mechanical installation. There are two ways to accomplish this phase adjustment
mechanically or electronically.
The SRT-422 Motor drive is packaged in a compact case. A ¼” shaft with flat, provides
the output drive.
Figure 3.1: SRT-422 Motor Drive unit.
Section 3.2: Electrical Connections and Descriptions
Line Voltages
Unit is capable of running on both 230 Volts and 115 Volts. There is a switch located on
the connector panel of the unit to select for the proper voltage requirements.