INFICON Crystal 12 Sensor - Manual (Page 15)

1 - 3
07
4-
39
8-
P1A
Crystal12 Sensor Operating Manual
1.1.2 Materials
1.1.3 Unpacking Instructions
The Crystal12 sensor and accessories are packaged in a single cardboard carton
with rigid foam inserts.
Carefully remove the packaged accessories before removing the sensor.
The unit in the shipped condition has been aligned at the factory, no further
alignment is required.
During shipment, units may vibrate slightly out of position. This does not mean
alignment is required. The unit will return to the centered position the first time it is
pneumatically activated.
Table 1-2 Materials
Plate, Material Shield, Mechanical Parts,
Body and Carousel 304 type stainless steel
Springs, Electrical Contacts Au plated Be-Cu, Au Plate 302 stainless
steel
Water and air tubes S-304, 0.125" (3.2 mm) O.D. x .016"
(0.4 mm) Wall Thickness x 30" Long (762
mm) Seamless Stainless Steel Tubing
Connector Stainless steel
Insulators Teflon®, Peek®
Cable Teflon insulated copper plated steel
Crystal 0.550" (13.97 mm) Diameter