INFICON VGC403 Three-Channel Measurement and Control Unit - Manual (Page 6)

6
tinb07e1-e 2011-07 Vacuum Gauge Controller
1.4.4 Disconnecting device
The Vacuum Gauge Controller is equipped with a discon-
necting device according to EN 61010-1.
The disconnecting device is located at the back of the
Vacuum Gauge Controller. See Fig. 1-3,  6.
The disconnecting device must be readily identifiable and
easily reached by the user.
In order to disconnect the Vacuum Gauge Controller from
mains, you must unplug the mains cable.
Fig. 1-3 Back side of the VGC403
A Disconnecting device
WARNING
Improper installation and operation data.
Improper installation and operation data may
damage the Vacuum Gauge Controller.
Strictly adhere to the stipulated installation
and operation data.
A