JUMO 902940 DELOS T Electronic Temperature Switch with Display and Analog Output Operating Manual - Manual (Page 21)

21
3 Electrical connection
3.1 Installation notes
• Ensure that the fuses of the load circuits are suitable for the maximum loads to avoid dam-
age to the device.
• The electromagnetic compatibility meets standard EN 61326.
• Do not connect any additional consumers to the voltage supply of the device.
• The device is not suitable for use in areas with an explosion hazard (Ex areas).
• In addition to a faulty installation, also incorrectly set values on the device could impair the
orderly function of the following process or lead to damage. For this reason, always provide
safety devices/guards independent of the device, the setting of which is restricted to expert
personnel.
3.2 Device connection assignment for M 12x1 machine connec-
tor
The connection is located on the device rear!
CAUTION!
The electrical connection must only be carried out by qualified personnel!
TIP!
The assignment only applies to A-coded standard cables.
1 brown (bn) 2 white (wh)
3 blue (bu) 4 black (bk)
5 gray (gy)