3 operation cancellation, Operation cancellation, 6 commissioning/start-up – JUMO 902940 DELOS T Electronic Temperature Switch with Display and Analog Output Operating Manual User Manual
Page 43
43
6 Commissioning/start-up
How to proceed:
6.3
Operation cancellation
How to proceed:
Step
Activity
1
Remove the locking screw (1) using a suitable screwdriver.
2
Briefly press the combination tool (2) until the third "0" (counted from the left) flashes.
Display previously changes to "red".
3
Turn the combination tool until "7" appears. Briefly press the combination tool.
4
Briefly press the combination tool until the fourth "0" (counted from the left) flashes.
5
Turn the combination tool until "2" appears. Briefly press the combination tool.
6
The device automatically changes over to the parameter level.
If an incorrect code was entered:
The display automatically changes over to the code entry after 3 seconds (or press the
combination tool). Repeat steps 2 to 5.
Step
Activity
1
Press the combination tool for more than 3 seconds or
2
wait for "Timeout" (no action for more than 60 seconds).