JUMO 706021 LOGOLINE 500d Line Recorder Operating Manual - Manual (Page 21)

6 Preparation
21
Timed operation This chart speed applies within a programmable time
period. Outside this period the chart is advanced at the
speed programmed as normal speed.
 Section 8.5.4
Section 10.4
Recording
Scaling The scale can be printed in two different modes:
cyclic:
for each channel at a configured spacing
triggered: for all channels by pressing key (key F,
hold down at least 4 sec) or by closing
a logic input
 Section 7.4
Section 8.4.3
Plotarea During plotarea operation a portion of the total measur-
ing range of a trace is recorded to a larger scale.
 Section 8.4.6
Section 10.4
Offset Using the parameter “offset” it is possible to define the
presentation range of a trace on the chart.
 Section 8.4.7
Section 10.4
Pen offset compensation There is an offset of several millimetres between the
fibre pens of the individual channels.
When pen offset compensation is switched on, this pen
offset is compensated automatically.
 Section 8.5.7
Section 10.4
Operating mode/status Description