JUMO 706021 LOGOLINE 500d Line Recorder Operating Manual - Manual (Page 64)

8 Programming
64
8.4.2 Measurement/signal input
The input signal/sensor type is selected
and the measurement ranges as well as the
filter time constants for each input channel
are defined.

If customized tables are used for
the linearisation of the input signals,
the measurement inputs and the
customized tables have to be set us-
ing the setup program.

With inputs for resistance thermom-
eter, thermocouple, current or volt-
age, the temperature values set at
the signal input are automatically
copied to the scaling after editing.
This does not apply, if linear, cus-
tomized table 1 or customized
table 2 has been configured as line-
arisation.
Display Edit Selection/input with keys Enter Continue with
INPUT
E
1 INPUT
Input number of input
channel
h
,
R E 
2

2 1 TYPE: RTD
THERMOCOUPLE
1
POTENTIOMETER
RES.TRANSMITTER
VOLTAGE
CURRENT
h
,
R E 
3

4

5

6

7

8
1. The cold junction temperature of the internal cold junction is measured on channel 1. It is also valid for channels 2 and 3.
If one or more thermocouple inputs are configured with an internal cold junction, a thermocouple with internal cold junction
measurement or external constant cold junction temperature has to be configured for channel 1.