JUMO 706021 LOGOLINE 500d Line Recorder Operating Manual - Manual (Page 50)

8 Programming
50
8.2.1 Chart speed
The standard chart speed for signal tracing
is set here.
The chart speed is selected in steps from a
table of standard chart speeds, or can be
programmed continuously to any value be-
tween 0 and 7200 mm/h.
Standard chart speeds are:
0, 5, 10, 20, 60, 120, 240, 300, 360, 600,
720, 1800, 3600 und 7200 mm/h.

The programming mode is factory-
set to standard chart speeds.
In the setup program the program-
ming mode can be changed to con-
tinuous under
Edit  Chart Speed... .
For alteration on the instrument
 Section 8.5.2

Please note Section 7.2
Display Edit Selection/input with keys Enter Continue with
FEED PAPER
E

with
step speed
programming:
FEED PAPER:
0240 mm/h
Select chart speed:
0, 5, 10, 20, 60, 120, 240,
300, 360, 600, 720, 1800,
3600, 7200 mm/h
h
,
R E h
forwards
R
backwards

with
continuous
speed
programming:
0000
set required chart speed
value range:
0 — 7200 mm/h
h
,
R
l
,
r
E
test:
speed value
h
forwards
R
backwards