Rockshaft installation – Landoll MCL/MCC/MCLS/MLCS/MCCS 1483, 1643, 1803 RIGID PULVI-MULCHER User Manual
Page 13
ASSEMBLY
2-3
Rockshaft Installation
Install Rockshaft using parts from the 8J061 Rockshaft
Box Assembly.
1.
Coat the bearing surface of the Bearing Assemblies
with grease before fastening Rockshaft to Frame with
5/8-11” X 7” Bolts, Washers and Hex Nuts.
2.
Install the base end of the 3 1/2” X 16” Hydraulic
Cylinder using one of the vendor provided pins. The
rod end of the Cylinder will be attached to the
Rockshaft lug at the same time as the linkage. See
Figure 2-5.
3.
Mount a Wheel and Tire Assembly onto each hub
with 1/2-20” X 1” Wheel Bolts. Torque to 80-85 ft/lbs.
4.
Tighten all hardware to the recommended torques.
See Page 4-1.
Figure 2-3: Rockshaft
Washer
Hex Nut, 5/8-11
9D653
Bearing
6D309
Bearing
Wheel &
Tire Assy
Bolt, 5/8-11 X 7
Bolt, 5/8-11 X 7
Vendor
Supplied
Item
3 ½ X 16
Hyd Cyl