Landoll MCL/MCC/MCLS/MLCS/MCCS 1483, 1643, 1803 RIGID PULVI-MULCHER - Manual (Page 14)

2-4 1K044
ASSEMBLY
8J083 Link Installation
1. On the Front Frame Tube, Install the bottom 8J118
Spacer using a Bolt 1/2-13” X 5” and Lock Nuts
1/2-13”. Do not over tighten - Spacer must be able to
rotate. See Figure 2-4.
Figure 2-4: Spacer Installation
2. Attach the rod end of the Cylinder to the Rockshaft
and the end of the 8J083 link having one hole. Use a
1” X 5 1/2” Pin and 1” Washers. The pin should not
be locked in place until later when further assembly is
done here. See Figure 2-5.
3. Install hoses and relief valve at this time. See
Figures 2-24 and 2-25. Also refer to the Hydraulic
pages in the repair Parts Manual 1K045 for parts
involved in the assembly.
Spacer
Locknut
1/2-13
Bolt 1/2-13 X 5