Landoll MCL/MCC/MCLS/MLCS/MCCS 1483, 1643, 1803 RIGID PULVI-MULCHER - Manual (Page 17)

ASSEMBLY
2-7
Spring Linkage Assembly
Install the Spring Linkage between the front Frame Tube
and Drawbar. Use U-bolt, Springs, four Spring Caps and
two 5/8" Lock Nuts. Also used are a 1" X 7 1/2” Pin, two
1" I.D. X 11/16" Spacers, four 1" Washers and two 1/4" X
2" Roll Pins.
Install the Bumper at the top of post on the Drawbar
using six 8J903 Spacers and two Hair Pin Cotters. See
Figure 2-7.
Figure 2-7: Spring Linkage Installation
Spring Linkage
Drawbar
Center Mast
Spacers
Bumper
Hairpin Cotters
Pin, 1 X 7 1/2,
Spacer, Washer and
Roll Pin
U-Bolt
Lock Nuts
Springs
Spring Caps
Flat Washer
Spring Linkage
Bumper
Hair Pin
Cotters
8J903
Spacers
Flat Washer
Spacer
Cylinder Pin
Roll Pin