Leica Biosystems LN22 - Manual (Page 21)

21
4.5 Connecting to mains
4.5.1 Checking the voltage selector setting
The voltage selector is preset to 230V in the factory.
Before connecting the instrument to the mains power, please
check whether the factory setting is identical with the local mains
power in your lab!
Severe damage may be caused to the instrument when operating it
at an incorrect voltage setting.
The voltage selector is located behind the cover of the voltage selector
housing (3) next to the mains switch (2) on the rear of the control unit.
The actual voltage setting can be seen in a small indication window (1) in
the cover (3). See the figure on the following page!
Check that the voltage selector setting that shows in the window
(1) is the appropriate one for the mains supply in your lab.
If the voltage shown in the indication window does not correspond to
your local mains supply, the voltage selector setting MUST be changed
to the appropriate values for your lab prior to connecting the instrument
to the mains supply.
4. Startup