Leica Biosystems LN22 - Manual (Page 24)

24 Instructions for Use V1.2, RevB – 10/2012
4.5.5 Connecting the mains cable
The instrument is delivered with various country-specific mains ca-
bles.
The instrument may only be connected to a grounded mains power
outlet socket. To connect the instrument, only use one of the mains
cables that are supplied together with the instrument!
• Before plugging in the mains cable, check whether the mains switch
(1, Fig. 16) on the rear side of the control unit (14, Fig. 16) is in ‘O’ (OFF)
position.
• From the set of mains cables, select the one with the plug that fits into
your wall outlet.
• Insert the connector plug of the mains cable into socket (5, Fig. 16).
• Plug the mains plug into the wall outlet.
The instrument is now ready for use.
4.6 Switching on the instrument
Switching on the cryochamber illumination
The switch (1) for the cryochamber illumination is
located on the left side of the cryochamber.
The light has to be on as long as the knife
is inside the cryochamber!
1
Fig. 17
4. Startup
• Switch on the mains switch at the rear of the
control unit (1, Fig. 16).
First, the software version will be displayed for a
few seconds. Then the actual temperature of
specimen (1, Fig. 18 a), knife (2, Fig. 18 b) and
chamber gas (3, Fig. 18c) is displayed.