Lenze IM94MV01C - Manual (Page 13)

IM94MV01C 11
. Configure IP Address of Drive:
3. The first time in a session, click [Project] then [Connection Setup] or click the [ ] icon and select the proper inter-
face from the list.
4. Select [Node] then [Connect drive] or click the [ ] icon. The connection dialog opens as illustrated in Figure 10.
5. Specify the IP address(es) of the drive(s) to connect to. Refer to paragraph 1.6 “Build Ethernet Connection List” for
details.
6. Click the [Connect] button.
7. The Drive(s) with the specified address(es) will be connected and shown in the Node Tree.
Figure 10e: Composite Screenshot - Connection using 10/100 Ethernet
1.4.3 Disconnect or Remove a Drive
To disconnect a drive: Select the drive by clicking on its icon on the left tree. Click [Node] on the main menu then [Disconnect]
from the pull-down menu or click the [ ] icon. MotionView will prompt to [save the current settings to file] before it discon-
nects the drive. The user can reconnect the drive later by selecting [Node] on the main menu then [Connect drive] from the
pull-down menu.
To remove a drive or file from the Node Tree: Select the drive or file by clicking on its icon on the left tree. Select [Node] from
the main menu then [Remove node from project] from the pull-down menu.
Note:
A connection does not need to be setup every time the user connects. A connection needs to be setup only once
per session or any time the communication settings are changed.
If the work is saved to a project file then the connection does not need to be setup unless different communica-
tion settings are used. Re-save the project file if changes are made to it.