Lenze IM94MV01C - Manual (Page 4)

 IM94MV01C
Safety Warnings
WARNING!
• Hazard of unexpected motor starting! When using MotionView software, or otherwise operating the
PositionServo drive over RS-3/485, CANopen or Ethernet, the motor may start unexpectedly, which may
result in damage to equipment and/or injury to personnel. Make sure the equipment is free to operate in this
manner, and that all guards and covers are in place to protect personnel.
DANGER!
• Hazard of electrical shock! Circuit potentials are at 115 VAC, 30 VAC or 480 VAC above earth ground.
Avoid direct contact with the printed circuit board or with circuit elements to prevent the risk of serious
injury or fatality. Disconnect incoming power and wait 60 seconds before servicing drive. Capacitors retain
charge after power is removed.
NOTE
• The symbol shown at left indicates additional information, shortcuts, or tips that do not affect the safe
operation of the drive.