Lenze IM94MV01C - Manual (Page 15)

IM94MV01C 13
1.7 File Operations
1.7.1 Opening and Closing Parameter Files.
To open an existing configuration file, click [Node] on the main menu then [Open configuration file] from the pull-down menu.
Select the configuration file with extension “.dcf” in the open window. The File will appear in the Node Tree on the left.
To save the file, click [Node] on the main menu then [Save configuration file] from the pull-down menu.
To remove a file from the Node Tree, click [Node] on the main menu then [Remove node from project] from the pull-down
menu.
1.7.2 Load Parameters from File to Drive.
To load data from a file to a drive, click [Node] on the main menu then [Load configuration file to drive] from the pull-down menu.
The Drive data will be updated with the file data.
Note:
For this operation the drive must be connected and DISABLED.
Parameters will not be loaded when the drive is enabled.
2 node Tree folders
Note:
Refer to the PositionServo User’s Manual (S94P01) and Programming Manual (PM94P01) for complete de-
scriptions of motor features and instructions for programming each parameter. To access the PositionServo
Programming Manual, click [Help] then click [Product manuals]. The information contained herein is a brief
description of the folders in the Node Tree that populate once a drive file is opened.
2.1 Drive
Click the Drive name in the Node Tree. The drive ID string, device family, firmware revision, vector processor revision, hardware
revision and serial number are displayed as illustrated in Figure 13. The drive indentification parameters are fixed and are
provided for information only.
Figure 13: Drive ID String