Metal Sales Image II Installation - Manual (Page 27)

© Metal Sales Manufacturing Corporation / Subject to change without notice, effective 6/2011
27
Rakewall with Counter Detail
1. If the panel ends off module, bend flat part of the panel up a
minimum of 1", otherwise skip to the next note.
2. Apply a row of Double Bead Tape Sealant to the flat part of the
panel next to the panel rib or vertical field bent leg.
3. Install Rakewall to the and attach with #9-16 x 1" Woodscrews,
1' o.c. to the flat pan of the Image II panel.
4. Install Counter Flashing, and fasten to parapet wall with
appropriate fastener 1' o.c. Seal Counter Flashing to parapet
wall with Tube Sealant.
5. If two or more flashings are required, lap the flashing over
the previously installed flashing by a minimum of 2" placing a
bead of Tube Sealant between the flashings and securing with
Pop Rivets, 2" o.c.
Image II Panel (1)
#9-16 x 1" Woodscrew,
1' o.c. (4)
Moisture Barrier
Tube Sealant (7)
Fasteners By Others (5)
Rakewall (3)
Counter Flashing (6)
Double Bead
Tape Sealant (2)
Optional Rakewall
With 1" Z-Closure
(X) Numbers indicate sequence of installation.