MK Diamond MK-770 EXP - Manual (Page 14)

(D)
Install the Height Adjusting Knob
through the Post into the Cutting
Head and tighten the Knob
14
UNPACKING, TRANSPORT, TILE SAW STAND and ASSEMBLY
ASSEMBLY:
Follow the assembly instructions to prepare your MK-770 EXP for operation.
1. Cutting Head Installation:
NOTE: If the Cutting Head is installed, go to step 2.
(B)
Align Cutting Head Pivot Hole
to the Post, Pivot Shaft
(A)
Place the Flat Washer onto
the Height Adjusting Knob
(C)
Verify the Cutting Head is
completely installed and
seated on the Post
(B)
Loosen the Blade Guard,
Retaining Wing nut
(A)
Loosen and remove the Blade
Guard, Retaining Knob
(C)
Open the Blade Guard
2. Diamond Blade Installation:
NOTE: When installing the Retaining Screw, do not "cross-thread" and DO NOT over tighten the screw.
Flat Washer
Post
Pivot Shaft
Installed
Rotate ClockWise
to open