MK Diamond MK-770 EXP - Manual (Page 25)

25
SETUP, ADJUSTMENT & OPERATION
CLEANUP
NOTES: 1. If an external water source was used, steps A through C may be skipped.
2. Dispose of wastewater in accordance with applicable Federal, State and Local laws.
(B)
Place the Water Pump in an
external container
(A)
Clean the Water Pump
suction of all debris
(C)
Run the MK-770 EXP until
clear water is seen at the
blade Cooling Flow Points
(Approx. 1 minute)retaining
thumbscrew
(D)
Ensure the ON/OFF Switch is
in the OFF position. Unplug the
saw from the power source.
Ensure the saw is disconnected before completing the remainder of the cleanup process.
(F)
Remove the Water Pan from
the MK-770 EXP
(E)
Clean the MK-770 EXP with
soap and clean water
(G)
Clean the Water Pan
Pump
Suction
CAUTION