MK Diamond MK-770 EXP - Manual (Page 21)

21
SETUP, ADJUSTMENT & OPERATION
2. Cutting 45° Miters:
DO NOT FORCE THE TOOL. It will do the job better and safer at the rate for which it was
designed.
(B)
Pivot the Cutting Head to the
45º cutting position
(A)
Loosen the Cutting Head
Pivot, Retaining Knob
(C)
Tighten the Cutting Head,
Pivot Retaining Knob
(E)
Position the Adjustable
Cutting Guide to desired cut
length indicated inside the
diamond
(D)
Loosen the Adjustable Cutting
Guide retaining thumbscrew
(F)
Tighten the retaining
thumbscrew
The MK-770 EXP is designed with an adjustable Cutting Head for precision 45º Miter Cuts.
(H)
Turn the motor ON
(G)
Place the tile against the
Ruler/Stop and Cutting Guide
(I)
Verify cooling flow on both
sides of the blade
Pivot Direction
Desired cut length
indicated here
CAUTION