MK Diamond MK-770 EXP - Manual (Page 32)

32
MAINTENANCE AND TROUBLESHOOTING
NOTE: If alignment problems are the result of a warped blade, a bent frame or bent support arm, or, if
alignment is off by more than 1/8-inch, contact the MK Diamond Service Center – (800) 474-5594
Combination Square
12-inch or Greater
Flat Head Screwdriver 1/4-inch Wrench Metal Straight Edge
(B)
Remove Water Pan
(A)
Remove Tile Saw
from Power Source
(C)
Inspect Tile Saw
for damage
(D)
Inspect Diamond Blade
for damage
The Movable Cutting Table of the MK-770 is pre-aligned in the factory. It may become misaligned with the
Cutting Head of the Tile Saw over time. Should misalignment occur, perform the following steps to realign it.
TOOLS NEEDED:
PREP
ARA
TION:
TABLE ALIGNMENT: